器件名称: MSA002
功能描述: Mounting Instruction
文件大小: 524.74KB 共2页
简 介:Mounting Instruction MSA 002, 003
Important!
The measuring length of the Linear Encoder must be longer than the travel length of the machine! Remove transport brackets prior to operation Never tilt the encoder head with respect to the extrusion Do not connect or disconnect the encoder head with the Digital Readout or Control if the power is on. The Linear Encoder is not protected against dust and water drops. Do not touch the connector pins! (ESD-Instrucion) Overall cable length should not exceed 30 m!
Mounting of the extrusion
First, mount the extrusion and loosely tighten the mounting screws. Adjust the mounting so that the extrusion is parallel to the machine guideway, and tighten the mounting screws according to the specifications.
Inspection of the mounting
Move the slide over the full range of motion to make sure that full machine movement range can be obtained without the encoder contacting the end of the scale extrusion. Otherwise, the Linear Encoder will be damaged!
Tying down the cables
Lay the cable so that the minimal bending radius is not exceeded. When you have mounted the encoder head at the moving part of your machine, the cable should be laying in a drag-chain. Overall cable length should not exceed 30 m!
Mounting notes
The best location for mounting a Linear Encoder is to mount it as close to the centerline of the slide, or as close to the guideways of the machine, as possible. To mount the Linear Encoder, two mounting surfaces are required……